When the car testing line should go to a special site, first of all, this car testing equipment place to have the basic testing service capacity, followed by:
1、 The test site should be installed in the waiting area obvious display device to provide information services for customers.
2、 Automotive testing equipment sites should be within a reasonable layout of the area, the site should be in a convenient location to facilitate vehicle testing. Testing sites should be in line with relevant environmental protection laws, regulations and standards requirements, should avoid the adverse effects on the surrounding environment.
3、The test site is generally composed of testing plant, reception area and outdoor car road.
4、The customer waiting area and testing area within the automotive testing equipment premises should be set up separately, and clearly marked.
5、The test site should be set up to limit the vehicle device.
6、The testing station shall comply with the relevant safety 8 regulations. Should be equipped with fire-fighting devices.
7、The test line for heavy-duty vehicle testing, the passing height of the test plant should be no less than 4.5 meters; testing line for light vehicle testing, the passing height of the test plant should be no less than 3.5 meters; the width of the motorway into the test plant is not less than 5 meters.

8、Automotive testing equipment places should be testing procedures notice board and fee notice board, the site should be hard ground and level, set up a clear guide signs.
9、the test site should be installed with an effective ventilation system to prevent the gathering of motor vehicle exhaust, should be equipped with effective noise pollution prevention measures. The temperature of the working environment should meet the relevant testing standards and testing equipment to work properly.
10、Test equipment and test vehicles should be surrounded by protective devices to ensure the safety of operation and to ensure the normal work of personnel space for activities. Communication facilities for the exchange of information between the driver operator and the operator of the testing system for automotive testing equipment should be installed. Emergency buttons should be installed at appropriate locations, through which the operator of the testing system can warn the driver operator to stop the test and turn off the test power.

Today’s content is introduced here, the follow-up to share with you more detection line content.